WaterRower M1 SERIES Owner's Manual - page 11
of
28
11
STEP 1
Lay the rails on the floor and connect the rear spacer using 4 (2 on either side)
of the male button head screws and the Allen key provided.
Button Head Screw x 4
5mm Allen Key
x2
x2
Note: The black extrusions are positioned on the inside.
Rear Spacer
STEP 2
Place the seat assembly between the rails with the indent facing towards the
rear spacer. The larger vertically mounted wheels (the load wheels) should sit
on the plastic extrusions on the top of the rail. The smaller horizontal wheels
below the seat (the guide wheels) should sit between the rails. It may be
necessary to separate the rails slightly to allow the guide wheels to fit down
between the rails.
STEP 3
Place the tank assembly between the rails.