WaterRower M1 SERIES Owner's Manual - page 16
16
1) To pump water, turn the knob clockwise to close valve as shown in figure A
2) Locate water source above (higher than) water destination:
▪
See Figure B for filling tank
▪
See Figure C for emptying tank
3) Squeeze pump 4-5 times until water flows
4) Turn knob counter-clockwise to allow air into the pump and
end syphon.
HOW TO FILL AND EMPTY THE TANK
A
B
C
TROUBLESHOOTING
1. Monitor flashing zeros
Solution 1: Try raising the sensor disk (located on top of the clutch). During
shipment, the disk may have shifted.
Solution 2: Loosen and retighten the bolts on the upper deck and forward riser. If
these bolts are not uniformly tightened during assembly, the alignment may be off.
2. Loosening bolts - over time and with use bolts can come loose. Use the 5mm Allen
key to gently tighten the bolts. If the bolts continue to loosen use a small amount of
medium strength Loctite
®
to fasten the nuts and bolts more securely.
3. Monitor not turning on - check the batteries positioned behind the monitor. Unscrew
the monitor and gently lift to access the battery pack.
4. Monitor not counting down - check the monitor and sensor connector is connected.
Check all wiring is intact.
5. Paddle not turning smoothly - Loosen all tank bolts and retighten. See instructions
at: http://www.waterrowerservice.com/pdfs/troubleshooting_all_rubbing_tank.pdf
For other troubleshooting and service tips:
www.waterrowerservice.com