WEG MW500 User Manual - page 28
22 | MW500
Keypad (HMIR) and Basic Programming
- English -
Figure 4.3
illustrates the basic browsing of the operating modes of the HMIR.
Monitoring Mode
It is the initial status of the HMIR after the
powering up and of the initialization screen,
with default values.
The field Menu is not active in this mode.
The main display, secondary display and bar
graph indicate the values of three parameters
predefined by P0205, P0206 and P0207.
From the monitoring mode, when you press
the key
ENTER/MENU, you commute to the
setting mode.
Monitoring
Setting
Level 1
Setting
Level 2
Setting
Level 3
BACK
ESC
BACK
ESC
BACK
ESC
ENTER
MENU
ENTER
MENU
ENTER
MENU
Setting Mode
Level 1:
This is the first level of the setting mode. It is
possible to choose the parameter group using
the keys and .
The main display, secondary display, bar
graph and measurement units are not shown
in this level.
Press the key
ENTER/MENU to go to level 2 of
the setting mode – parameter selection.
Press the key
BACK/ESC to return to the
monitoring mode.
Level 2:
The number of the parameter is shown on the
main display and its content on the secondary
display.
Use the keys and to find the desired
parameter.
Press the key
ENTER/MENU to go to level
3 of the setting mode – modification of the
parameter content.
Press the key
BACK/ESC to return to level 1
of the setting mode.
Level 3:
The content of the parameter is shown on the
main display and the number of the parameter
is shown on the secondary display.
Use the keys and to configure the new
value for the selected parameter.
Press the key
ENTER/MENU to confirm the
modification (save the new value) or
BACK/
ESC to cancel the modification (not save the
new value). In both cases, the HMIR returns to
level 2 of the setting mode.
Figure 4.3: Operating modes of the HMIR