WEG MW500 User Manual - page 34

28 | MW500

Powering up and Start-up

- English -

5.3.2 STARTUP Menu (Using Remote Keypad (HMIR)) 

The start-up is explained in a very simple way, using the programming features with the 

existing parameter groups in the menus STARTUP and BASIC.

After the hardware pre-configuration, the drive will operate with a different control type.

5.3.2.1 V/f Control Type (P0202 = 0) 

Seq

Indication on the Display / Action

Seq

Indication on the Display / Action

1

6

Monitoring mode.

Press the key 

ENTER/MENU to enter 1st 

level of programming mode.

If necessary, modify the content of “P0401 – 

Motor Rated Current”.

Press the key  for the next parameter.

2

7

The 

PARAM group is selected, press the 

keys  or  until selecting the 

STARTUP 

group.

If necessary, modify the content of “P0402 – 

Motor Rated Speed”.

Press the key  for the next parameter.

3

8

When the 

STARTUP group is selected 

press the key 

ENTER/MENU.

If necessary, modify the content of “P0403 – 

Motor Rated Frequency”.

Press the key  for the next parameter.

4

9

If necessary, press 

ENTER/MENU to 

modify the content of “P0202 – Control 

Type” for P0202 = 0 (V/f).

To end the Start-up routine, press the Key 

BACK/ESC.

To return to the monitoring mode, press the key   

BACK/ESC again.

5

When the desired value is reached, press 

ENTER/MENU to save the modification.

Press the key  for the next parameter.

Figure 5.4: Sequence of the Start-up group for V/f control