WEG MW500 User Manual - page 53
Manual is about: Frequency inverter
of
53
Appendix C
A
pp
end
ix
C
MW500 | 47
Wall Mounting Instructions
Step
Action
Step
Action
1
3
For wall mounting, use the adaptation plate
accessory.
Use a cable gland to install the input power
supply (X1 terminal block) and output
motor wire (X2 terminal block). If necessary
connect the PTC terminals to XC5 (PTC
connector).
2
4
Fix the plate with the motor seal and 10
stainless steel screws in the rear of the drive.
Close the drive and don’t forget to connect
the ground plug to the front cover.
Figure C.2: Wall mounting instructions