WEG MW500 User Manual - page 36

30 | MW500

Powering up and Start-up

- English -

Seq

Indication on the Display / Action

Seq

Indication on the Display / Action

11

16

If necessary, modify the content of “P0403 – 

Motor Rated Frequency”, or press the Key  

for the next parameter.

At the end of the Self-Adjustment, the value 

of  P0408 automatically returns to “0”, as 

well as the  Status of 

“RUN” and “CONF” 

are cleared.

Press the key  for the next parameter.

12

17

If necessary, modify the content of “P0404 – 

Motor Rated Power”, or press the key  for 

the next parameter.

The result of Self-Adjustment is the value 

in ohms of the motor stator resistance 

shown in P0409.

This is the last parameter of the Self-

Adjustment of the V V W control mode. 

Press the key   to return to initial 

parameter P0202.

13

18

If necessary, modify the content of “P0407 – 

Motor Rated Power Factor”, or press the key 

 for the next parameter.

To exit the 

STARTUP menu, just press 

BACK/ESC.

14

19

At this point, the HMIR shows the option to do 

the self-adjustment. Whenever possible, perform 

the self-adjustment. Thus, to activate the self-

adjustment, change the value of P0408 to “1”.

Through the keys  and , select the 

desired menu or press the key 

BACK/ESC 

again to return directly to the monitoring 

mode of the HMIR.

15

 During the Self-Adjustment the HMIR will 

simultaneously indicate the status of 

“RUN” 

and 

“CONF”. And the bar graph indicates the 

progress of the operation.

 And the bar graph indicates the progress of 

the operation. The Self-Adjustment can be  

interrupted at any time by means of the key  .

Figure 5.5 (cont.): Sequence of the Start-up group for V VW control