Xerox DocuPrint P14 User Manual - page 89
Solving Printing Problems
Chapter 5: Troubleshooting
❖
5-11
Paper is not fed
into the printer.
Paper has not been loaded
correctly.
Remove the paper tray and reload the paper
correctly.
There is too much paper in the
paper tray.
Remove some of the paper from the tray.
The printer ejects
blank pages.
The laser print cartridge is out
of toner.
Replace the laser print cartridge. See the
section
Half of the page is
blank.
The page layout is too
complex.
Simplify the page layout and remove any
unnecessary graphics from the document, if
possible.
Install more memory. See
The page orientation setting
may be incorrect.
Change the page orientation in your
application program.
The paper size and the software
paper size settings do not
match.
Make sure the paper size in the software
settings matches the paper in the tray.
The printer cable specifications
may be incorrect.
Replace with the cable with an IEEE-1284
rated cable.
Table 5.1
Printer Operation Problems
(continued)
Problem
Possible Cause
Remedy
Table 5.1 Page 2 of 4