Xerox Phaser 6120 Service Manual - page 146
of
366
Disassembly/Assembly Procedures
Phaser® 6120 Color Laser Printer Service Manual
5-18
Precautions for Reinstallation of the High Voltage Unit
■
Make sure that the High Voltage Unit fits underneath the tab [4] as shown in the
following illustration.
■
During the reinstallation procedure, make sure that the rack terminal assembly [5] is
not deformed or left loose.
.
Waste Toner Near Full Detection Board (PWB-C)
1.
Remove the High Voltage Unit. See
2.
Remove the screw [1], unlock the tab [2], the wiring saddle [3], and then remove the shield
[4].
Caution:
Use caution when unlocking the tabs.
[4]
[5]
4139fs2029c0
[2]
[3]
[4]
[1]
4139fs2030c1