Xerox Phaser 6120 Service Manual - page 75
Phaser® 6120 Color Laser Printer Service Manual
3-19
TRANSFER BELT
CONNECTION SETUP
NETWORK SETUP
TCP/IP
DHCP/BOOTP
IP ADDRESS
DEFAULT ROUTER
SUBNET MASK
Function
Resets the transfer belt life count.
Use
To reset life count.
Setting/procedure
After the transfer belt is replaced, select QUALITY MENU
→
TRANSFER
BELT
→
RESET COUNT
Function
Sets whether to enable or disable TCP/IP.
Use
To disable TCP/IP.
Setting/procedure
The default setting is YES.
“YES”, NO
Function
Automatically acquires an IP address from the DHCP or BOOTP server, if
there is one in the network, and specifies whether to load other network
information.
Use
To automatically acquire an IP address and load other network information.
Setting/procedure
The default setting is YES.
“YES”, NO
Function
Sets the IP address of the printer on the network.
Use
To enter the printer’s IP address.
Setting/procedure
Enter the IP address using the up, down, right, and left arrow keys.
The default setting is “192.168.1.2.”
Note:
When the printer’s IP address is set manually, DHCP/BOOTP is
automatically set to OFF.
Function
Sets the IP address of the router if one is on the network.
Use
To enter the IP address of the router.
Setting/procedure
Enter the IP address using the up, down, right, and left arrow keys.
The default setting is “192.168.1.2.”
Function
Sets the subnet mask of the printer used on the network.
Use
To enter the printer subnet mask.
Setting/procedure
Enter the subnet mask using the up, down, right, and left arrow keys.
The default setting is “0.0.0.0.”