Yamaha TG500 Owner's Manual - Pb_Range

141

3-6-01: PITCH BEND, AFTER TOUCH

VOICE EDIT MODE / 3: Full Edit. 3-6: Controller

This screen includes parameters that set the TG500’s pitch bend range and the

aftertouch mode.

VCE CTRL                

 PB_Range=  

2  AT= ch's 

3-6-01: PITCH BEND, AFTER TOUCH

PB_Range 

(Pitch bend range)

Range:  0  …  12

Sets the maximum pitch bend range.

Each increment from “0” to “12” represents a semitone. A setting of “0”

produces no pitch bend. A setting of “12” allows a maximum pitch bend of

plus or minus one octave, while a setting of “4” allows a maximum pitch bend

of plus or minus a major third.

AT 

(Aftertouch mode)

Range:  ch’s,  key’s

Selects the channel or individual (polyphonic) key aftertouch response

mode. If “ch’s” is selected, the channel aftertouch response mode is engaged

and only a single aftertouch value is received via a single MIDI channel. If

“key’s” is selected, the individual key aftertouch repsonse mode is engaged and

individual aftertouch values are recognized for every note played.

[PLAY MODE] -> VCE PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-6: Controller -> [ENTER]

         -> [PAGE] -> 3-6-01: PB, AT -> [ENTER]