Yamaha TG500 Owner's Manual - 3-6-02: After Touch Depth

142

3-6-02: AFTER TOUCH DEPTH

VOICE EDIT MODE / 3: Full Edit. 3-6: Controller

For truly “intimate” modulation control, the TG500 allows a number of modula-

tion effects to be controlled via keyboard aftertouch response. The parameters in this

screen set the depth of the aftertouch modulation effects.

VCE CTRL AT Depth 

     3

5      0      20 é

3-6-02: AFTER TOUCH DEPTH

VCE CTRL AT Depth 

è    -6

4    127      0 

Amod 

(Amplitude modulation depth)

Range:  0  …  127

Sets the maximum depth of amplitude modulation (tremolo effects) applied

via keyboard aftertouch.

A setting of “0” allows no amplitude modulation, while a setting of 127

results in maximum amplitude modulation depth.

When setting up the low-frequency oscillator to apply amplitude modula-

tion, this parameter must be set to a value other than “0” if amplitude modula-

tion is to be applied via keyboard after touch.

Pmod 

(Pitch modulation depth)

Range:  0  …  127

Sets the maximum depth of pitch modulation (vibrato effects) applied via

keyboard aftertouch.

A setting of “0” allows no pitch modulation, while a setting of 127 results

in maximum amplitude modulation.

When setting up the low-frequency oscillator to apply pitch modulation, this

parameter must be set to a value other than “0” if pitch modulation is to be

applied via keyboard aftertouch.

Fmod

Pmod

Amod

Cof

PtBs

EGBs

[PLAY MODE] -> VCE PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-6: Controller -> [ENTER]  

       -> [PAGE] -> 3-6-02: AT Depth -> [ENTER]