Yamaha TG500 Owner's Manual - 3-1-05: Tune

66

3-1-05: TUNE

The fine tune parameters allow slight upward or downward pitch adjustment of

each layer, making it possible to create voice-thickening detune effects between

layers.

PERFORMANCE EDIT MODE / 3: Full Edit. 3-1: Layer

3: Full Edit. 3-1: Layer

Tune (layer A)

PFM Tune    [A] WN Flut1

0ÿ    0ÿ    0ÿ    0ÿ 

The layer to be edited can be selected as described on page 50. The currently

selected layer is shown in square brackets on the upper display line.

Fine 

(Fine tuning)

Range:  -7  …  +7

Use the [

,] and [.] keys (or the standard layer selection procedure) to select

the layer to be edited, then use the [-1/NO] and [+1/YES] keys to adjust the

pitch of the voice assigned to that layer. The maximum minus setting of

“-7” produces a downward pitch shift of approximately 2 cents (a “cent” is 1/

100th of a semitone), and the maximum plus setting of “+7” produces an

upward pitch shift of approximately 2 cents. A setting of “0” produces no pitch

change.

The Fine parameter allows different layers in a performance combination to

be slightly detuned in relation to each other, thereby “thickening” the overall

sound.

The name of the currently selected voice is shown in the upper right corner

of the display (“--------” appears if the voice is turned off). An animated musi-

cal note appears to the right of voices that are on and active (i.e. not muted).

[PLAY MODE] -> PFM PLAY -> [EDIT/COMPARE] -> 3: Full Edit -> [ENTER] -> 3-1:Layer -> [ENTER]

          ->  [PAGE] -> 3-1-05 : Tune -> [ENTER]