Yamaha TG500 Owner's Manual - 4-1: Sample Receive

246

UTILITY MODE / WAVE EDIT MODE / 4: Sample Dump

4-1: SAMPLE RECEIVE

This function initiates reception of MIDI Sample Dump data from an external

MIDI device. Both the MIDI IN and OUT terminals must be connected to the exter-

nal MIDI device, since the TG500 transmits a sample dump request message to

initiate transmission by the external device.

4-1: SAMPLE RECEIVE

UTL Sample Receive      

           sample= 0

1

sample 

(Sample number)

Range:  00  …  99

This parameter specifies the number of the sample to be received from the trans-

mitting device.

When ready to receive the data, press the [ENTER] key. The following

comfirmation display will appear:

UTL Sample Receive Sure?

           sample= 0

1

Press [+1/YES] to confirm that you want to go ahead with the reception, or press

[–1/NO] to cancel.

This initiates transmission of a sample dump request message, then the TG500

waits for the sample dump data. The received data is appended to the sample data

previously residing in the TG500 memory.

[UTILITY/SELECT] -> 5: Wave -> [ENTER] -> [EDIT/COMPARE] -> 4: Sample Dump -> [ENTER] -> [PAGE]

                                -> 4-1: Sample Receive -> [ENTER]