Yamaha Ultramatic GRIZZLY 660 Owner's Manual - page 112
8-19
8
NOTE:
The engine oil should be between the minimum
and maximum level marks.
7. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.
8. Insert the dipstick into the oil filler hole, and
then tighten the engine oil filler cap.
9. Install the panel.
To change the engine oil (with or without oil fil-
ter cartridge replacement)
1. Remove panel F. (See page 8-9.)
2. Place the ATV on a level surface.
3. Start the engine, warm it up for several min-
utes, and then turn it off.
4. Place an oil pan under the engine to collect
the used oil.
5. Remove the engine oil filler cap, and then re-
move the engine oil drain bolt to drain the oil
from the crankcase.
1. Maximum level mark
2. Minimum level mark
1. Engine oil drain bolt
U2C612E0.book Page 19 Wednesday, March 8, 2006 10:15 AM