Yamaha VL-1 Owner's Manual - 2: Dynamic Filter

115

Feature Reference

●

Edit Mode

and positive values increase the balance value (toward “wet”) at the corresponding

breakpoint. No matter what offset value is chosen, the actual balance setting will never

exceed its minimum or maximum absolute value. When different offset values are applied

to adjacent breakpoints, the balance varies smoothly between the breakpoints.

2: Dynamic Filter

•

The • button (“

Ctrl

”) can be used to go directly to the dynamic filter

controller page (

≥

 Page 77), also available from the ELEMENT CON-

TROLLER directory. You can then return to the modifier dynamic filter page

by pressing • (“

Para

”) again.

•

An inverse “K”(˚) next to a value means that key scaling can be applied to

that parameter. Position the cursor at the appropriate parameter and then press

the ¶ button (“

KSC

”) to go directly to the key scaling page for that param-

eter. You can return to the dynamic filter parameter page by pressing the

] button.

Element Modifier

● Filter Mode

≤

LPF, BPF, HPF, BEF.

Selects the filter mode.

Low-pass filter. Frequencies below the cutoff frequency are passed

while those above are cut off. The cutoff slope is -12 dB/octave.

Band-pass filter. In this case the “cutoff frequency” is actually the

center frequency of a narrow band of frequencies which will be passed.

The cutoff slope is -6 dB/octave.

High-pass filter. Frequencies above the cutoff frequency are passed

while those below are cut off. The cutoff slope is -12 dB/octave.

Band-eliminaton filter. The cutoff frequency is the center frequency of a

narrow band of frequencies which will be cut off. The cutoff slope is -6

dB/octave.

LPF

BPF

HPF

BEF

                In 

(from Harmonic

Enhancer)

   Out 

(to Frequency

Equalizer)

Dynamic

Filter

Wet/Dry

Balance