Yamaha VL-1 Owner's Manual - page 14
10
Feature Reference
●
General Operation
3.
If Necessary, Press
™ (“
Efct
”)
If the miscellaneous directory is showing (in this case “
Misc
” above the ¡ button
will be highlighted), press the ™ button below “
Efct
” on the display to select the
effect directory.
4.
Move the Cursor To “
4:Reverberation
” and Press
[
Use the cursor buttons (or the - and = buttons, or the data dial)
to move the cursor to “
4:Reverberation
” and press the [ button. This will
take you to the first page of reverb parameters.
NOTES■ Notice that the top line of the display shows the “path” to the current
level or function: “
EDIT/COM/EFFECT/REVERBERATION
”.
This example illustrates the two methods used to move downward through the EDIT
mode levels: 1) press the appropriate function button and 2) move the cursor to the
desired selection and press [.
From any point within the structure you can move upward toward the topmost level
(in this case the initial EDIT mode display) by pressing the ] button. You move up
one level each time the ] button is pressed, until the topmost level is reached.
To exit from the EDIT mode itself you must press either the P or U
button, depending on the mode you want to switch to. You can exit from the EDIT mode
at any level by doing this, and you will be returned automatically to the same display
page the next time you press the E button as long as the voice being edited is not
stored or a new voices is not selected.