Zebra 110XiIIIPlus Quick Reference Manual - Calibration
English
11347LB R4 6/4/04
EN-9
Calibration
After you have correctly installed the media and ribbon, turn the printer on. The printer
performs a Power-On Self Test (POST). When this is complete, the liquid crystal display
(LCD) reads “PRINTER READY.”
The printer then automatically calibrates. During this process, the printer feeds a few labels to
determine automatically the label length and ribbon sensor settings. This process is repeated
whenever the printhead is opened.
1.
Press PAUSE.
2.
Press CALIBRATE.
The printer feeds several labels.
3.
Press PAUSE.
CHECK RIBBON
Off
Normal operation—ribbon is properly loaded.
On
No ribbon is loaded (printer in Thermal Transfer Mode). Front panel
displays error message.
PAPER OUT
Off
Normal operation—media is properly loaded.
On
No media is under the media sensor. Printing is paused, the display
shows an error message, and the PAUSE light is on.
PAUSE
Off
Normal operation.
On
Printer has stopped all printing operations. Either PAUSE was pressed,
a pause command was included in the label format, the On-line Verifier
detected an error, or a run-time error was detected.
DATA
Off
Normal operation—no data being received or processed.
On
Data processing or printing is taking place—no data is being received.
Flashing
Printer is receiving data. Flashing slows when the printer cannot accept
more data, but returns to normal once data is again being received.
Table 3 • Front Panel Lights (Continued)
Light
Status
Indication
Important •
If autocalibration is turned off, perform the Ribbon and Media Calibration
procedure from the LCD menu whenever a different type of media or ribbon is installed.