Zebra 110XiIIIPlus Quick Reference Manual - page 8
EN-6
11347LB R4 6/4/04
English
Cutter Mode (
-E)
1.
Make sure that the Cutter option is available and installed on the printer.
2.
From the front panel, select the appropriate print mode.
3.
Load media according to the directions above for Tear-Off Mode, except feed the media
through the cutter module as shown in
-E.
Fanfold Media Loading (
)
Fanfold media can be placed in the bottom of the media compartment, in the fanfold supply
bin, or outside of the printer with access through the bottom or the rear.
Adjust the media guide (
-M) thumbscrew to keep the media from drifting; make sure
it is parallel to the edge of the media.
Figure 3 • Fanfold Media Loading
Ribbon Loading
Refer to
. When loading ribbon, make sure that the ribbon core is pushed up against
the stop on the ribbon supply spindle (
-D).
Do not use ribbon narrower than the
media.
1.
Align the segments of the ribbon supply spindle (
).
2.
Place the ribbon roll on the ribbon supply spindle (
-D).
3.
Make a leader for your ribbon. Tear off a strip of media (labels and backing) about 6 in. to
12 in. (15 cm to 30 cm) long. Peel off a label from this strip. Apply half of this label to
the end of the strip and the other half to the end of the ribbon. This acts as a ribbon leader.
4.
Open the printhead (
-A) and thread the leader and attached ribbon through the
print mechanism, under the upper roller (
-K), and past the platen roller
(
-J).
5.
Before wrapping the ribbon around the ribbon take-up spindle, ensure that the arrow on
the knob aligns with the indented notch (see inset,
Caution •
The cutter blade is sharp. Do not touch or rub the blade with your fingers.
Note •
For the 170
Xi
III
Plus
and 220
Xi
III
Plus
, thread the leader first through the dancer
roller assembly (