Zebra 110XiIIIPlus Quick Reference Manual - page 7
English
11347LB R4 6/4/04
EN-5
6.
After all of the above steps have been completed, close the printhead open lever to lock
the media in place. If not aligned correctly, the material may not rewind properly on the
rewind spindle/core; that may, in turn, affect media movement and/or printing.
1.
From the front panel, select the appropriate print mode.
2.
Remove the media rewind plate (
-F) from its storage location in front of the print
mechanism inside the media compartment.
3.
Invert the rewind plate so that the lip on the attached hook plate (
-G) points down.
4.
Insert the hook plate lip into the lower opening in the side plate.
5.
(Only for printers with just the Rewind option,
Align the upper end of the
rewind plate with the matching slot in the side plate.
6.
Slide the rewind plate in so that it stops against the main frame.
7.
(Only for printers with Cutter/Rewind option,
-D)
Insert the two small tabs on the
rewind plate into the corresponding slots in the cutter support bracket. The rewind plate
should “spring” into the proper position.
8.
Load media according to the directions for Tear-Off Mode. When loading the media,
allow about 1 yd. or 1 m of media to extend past the tear-off bar. If using label stock,
remove all labels from this portion of the media to create a leader.
9.
(Only for printers with Cutter/Rewind option,
-D)
Feed the labels through the
cutter mechanism.
10.
Remove the hook (
-G) from the take-up spindle shaft (
-H). If you are
using a core, remove all tape from the core and slide it onto the rewind spindle until it is
flush against the guide plate.
11.
Route the media as shown in
and
and wind it 1 to 2 times around either
(1) the media take-up spindle and reinstall the hook, or (2) a 3
″
(7,6 cm) core. (With some
types of media, especially tag stock, you may need to tape the end of the media to the core
if it will not tighten onto the core. DO NOT tape the label stock unless absolutely
necessary.)
12.
After all of the above steps have been completed, close the printhead open lever to lock
the media in place. If not aligned correctly, the material may not rewind properly on the
rewind spindle/core which may, in turn, affect media movement and/or printing.
Note •
For best results, install the printer on a level surface. This is especially helpful with
wider printers using wide media. If the surface is not level, the media may “telescope” off of
the rewind spindle, causing unsatisfactory results.
Caution •
The cutter blade is sharp. Do not touch or rub the blade with your fingers.
Note •
Before closing the printhead open lever, make sure that throughout the media
pathway (1) the media is positioned against the inside guides, and the outer guide and
media supply guide barely touch the media, (2) the media is taut, and (3) the media is
parallel with itself and with the pathway when wound on the rewind spindle/core.