Zebra 110XiIIIPlus Quick Reference Manual - page 13
English
11347LB R4 6/4/04
EN-11
SENSOR TYPE
Press the oval keys to select web or mark sensing mode. If your media
does not have black marks on the back, leave your printer at the default
(web) setting.
PRINT METHOD
Press the oval keys to select the method of printing you want to use:
direct thermal (no ribbon) or thermal transfer (using thermal transfer
media and ribbon).
PRINT WIDTH
Press the oval keys to set the printer to the width of your media.
MAXIMUM
LENGTH
Press the oval keys to set the maximum print length. Select the value
closest to but not less than the length of label you are using.
LIST FONTS
Press the right oval key to print a list of available fonts.
LIST BAR CODES
Press the right oval key to print a list of available bar codes.
LIST IMAGES
Press the right oval key to print a list of available images.
LIST FORMATS
Press the right oval key to print a list of all formats currently stored in
the printer’s DRAM, optional EPROM, or on an optional memory card.
LIST SETUP
Press the right oval key to print a list of the current printer configuration
settings.
LIST ALL
Press the right oval key to print a list of fonts, bar codes, images,
formats, and the current print engine configuration settings.
SAVE CHANGES
Press the oval keys to select:
PERMANENT: saves the changes when the power is turned off.
TEMPORARY: saves the changes until changed again or until power is
turned off.
CANCEL: cancels all changes since entering the Setup Mode.
LOAD DEFAULTS: loads factory default values for all parameters.
Note: Refer to the User Guide! This requires Calibration and resetting
of the Head Resistance.
LOAD LAST SAVE: loads values from the last permanent save.
Press
to accept a selection.
—
PRINTER READY
You have exited the Setup Mode and are now ready for normal printer
operation.
Table 4 • Configuring the Printer
Press:
LCD Shows:
Action/Explanation: