Zebra 110XiIIIPlus Quick Reference Manual - page 6
EN-4
11347LB R4 6/4/04
English
Roll Media Loading in Tear-Off Mode (
1.
From the front panel, select the appropriate print mode.
2.
Place the media roll (
-E) on the media supply hanger (
-F) or optional
supply spindle.
3.
Open the printhead by moving the lever located on the upper printhead assembly to the
open (
-A) position.
4.
Loosen the media guide (
-M) thumbscrew and position the media guide as far out
from the printer frame as possible.
5.
Thread the media under the dancer arm assembly (
-P), under the lower roller
(
-L), between the upper media guide plate and main media guide, under the
printhead, and over the platen (
6.
Adjust the media guide (
-M) position until it just touches the outer edge of the
media without causing it to buckle. Make sure it is parallel to the edge of the media, then
tighten the thumbscrew.
7.
Close the printhead by moving the lever located on the upper printhead assembly to the
closed (
-B) position.
8.
IMPORTANT: Perform the Media Sensor Position Adjustments found on page 15.
1.
From the front panel, select the appropriate print mode.
2.
If the rewind plate is installed in the printer, remove and store it on the two mounting
screws on the inside of the front panel. The notch in the rewind plate must face upward so
that the take label sensor can sense a peeled label.
3.
Load media according to the directions for Tear-Off Mode. When loading the media,
allow about 1 yd. or 1 m of media to extend past the tear-off bar. If using label stock,
remove all labels from this portion of the media to create a leader.
4.
Remove the hook (
-G) from the take-up spindle shaft (
-H). If you are
using a core, remove all tape from the core and slide it onto the rewind spindle until it is
flush against the guide plate.
5.
Wind the backing 1 to 2 times around the media take-up spindle and reinstall the spindle
hook (if necessary). Make sure that the media backing is against the backing guide plate.
(With some types of media, especially tag stock, you may need to tape the end of the
media to the core if it does not otherwise tighten onto the core. DO NOT tape the label
stock unless absolutely necessary.)
Note •
For best results, install the printer on a level surface. This is especially helpful with
wider printers using wide media. If the surface is not level, the media may “telescope” off of
the rewind spindle, causing unsatisfactory results.
Note •
Before closing the printhead open lever, make sure that throughout the media
pathway (1) the media is positioned against the inside guides, and the outer guide and
media supply guide barely touch the media, (2) the media is taut, and (3) the media is
parallel with itself and with the pathway when wound on the rewind spindle/core.