Zebra RW 420 Installation And User Manual - page 11
UMAN-RW4PS-101 • EN-17
1. While multiple interfaces can be connected, only one can be sending
data at a time.
2. As the External USB and External RJ45 USB interfaces use the same
USB port yet provide different connectors, only one connector can be
connected at a time.
3. Current Motorola MC70/75 terminal products do not implement USB.
When functionality is supported, it is assumed to be Host USB.
4. Terminal Bluetooth is assumed to be a host port.
5. DEX connection is not applicable in this case as there is no terminal
present.
6. This is not applicable, as there is no terminal docked to send information
to.
7. Bluetooth functionality of the printer and handheld are independent of
terminal dock state or DEX usage.
8. Part number can be found on mobile printer price list.
9. The Dex cable is used to communicate directly with the terminal. While
the Dex connector is plugged in, the serial communication between the
terminal and the print station is unavailable.
Wireless Communications with Bluetooth
Both the RW 420 Print Station and the terminal it communicates
with must follow the Bluetooth standard. Each Bluetooth enabled
RW 420 Print Station has a unique Bluetooth Device Address
(BDA) loaded into its radio module when manufactured. The BDA
lable is located in the terminal MC 70 dock, and it can be used for
scan-to-associate. A Bluetooth enabled RW 420 Print Station will
normally act as a Bluetooth slave creating a minature network
with the terminal sometimes refered to as a “piconet”. Please refer
to the RW series printer User Guide.
Setting Up the Software
The RW 420 Print Stations support the same programming
language as the RW series printer. Please refer to the RW series
printer User Guide.
Card Reader
The RW 420 Print Stations can be equipped with a Magnetic
stripe reader. Please refer to the RW series printer User Guide.
INSTALLATION
Installing the RW 420 Print Station in a Vehicle
INTRODUCTION TO INSTALLATION
If you will be running the RW 420 Print Station from a vehicle’s
electrical system you will need the following :
• An optional Vehicle Cradle (ref. Zebra p/n AK18822-1).