Zebra RW 420 Installation And User Manual - page 19
UMAN-RW4RP-103 • EN-25
CARE AND MAINTENANCE
The RW 420 Print Station requires little maintenance other than
routine cleaning.
Before performing any maintenance on the system, ensure it is
disconnected form any source of power. Use a damp cloth with a
mild detergent for cleaning and dry with a soft cloth. Do not use
strong products (solvents or anything similar). Avoid any liquid in
-
filtration into the system.
Do not use the RW 420 Print Station system if it shows evidence
of the following :
• It has been visibly damaged or tampered with.
• The system indicates a malfunction.
• It has been stored for a long period in unsuitable condi
-
tions.
Switch the device off immediately, disconnect it from the power
supply, and contact the authorized service provider.
Warning: To avoid possible personal injury or damage to the RW 420 Print
Station, never insert any pointed or sharp object into it or the terminal.
Caution: Use only the cleaning agents indicated. Zebra will not be
responsible for damage caused by any other cleaning materials used.
Any maintenance operation described below must be executed
with the Print Station disconnected from its power source.
Table 5: Maintenance Operations
Part
Method
Interval
Exterior
Remove the printer and the terminal, then clean with
water dampened cloth
6 months or as
necessary
Printer connection
contact
Release the printer. Remove any dust or other materials
with compressed dry air. Then clean with cleaning swab
and 70% isopropyl alcohol.
6 months or as
necessary
Terminal connection
contact
Remove the terminal. Remove any dust or other materials
with compressed dry air. Then clean with cleaning swab
and 70% isopropyl alcohol.
6 months or as
necessary
Power connector and
DEX connector
Remove dust or other materials with compressed dry air.
6 months or as
necessary
Terminal release
mechanism,
Visually check the connectors for any signs of damage
6 months or as
necessary
Check the hooks for terminal retention are elastic and
return in rest position.
3 months or as
necessary
Shoulder Strap
(optional)
Visually inspect the optional shoulder strap for any signs
of damage or excessive wear.
12 months or as
necessary