Zebra RW 420 Installation And User Manual - page 5
UMAN-RW4PS-101 • EN-11
Indicates a Bluetooth connection is established. This icon is
functional only on Print Station Series printers with a Bluetooth
wireless option installed.
A flashing icon indicates that the printer does not detect any
media. This could indicate an out of media condition, or
improperly loaded media, or the media door is open.
A flashing icon indicates that data is being transferred to the
printer.
A flashing outside element of the battery icon indicates low
charge status. You should suspend any printing operations and
recharge or replace the Battery Pack as soon as it is convenient.
Cycling charge level elements within the battery icon indicate the
Print Station Series battery is being charged, the cycling stops
when the battery is fully charged. Refer to the Charger section of
this manual.
Battery Charging % The Print Station Series battery is being charged while the unit is
off, “Battery Charging %” message displays on the screen.
If the printer displays: “Please Recondition the Battery”, the user should
recondition the battery to return it to optimal operation. To recondition the
battery, charge the battery fully overnight and then use the printer until the
printer shuts down due to a low battery condition.
Charge the battery again until it is fully charged. At that point the
battery will be reconditioned. If the battery is not reconditioned properly
the indicated battery charge level will be inaccurate. Reconditioning
performed as prompted by the printer will ensure accurate capacity
indication throughout the serviceable life of the battery pack.
Battery health is a parameter that determines the suitability of the pack
for service. It is computed on power-up and displayed on a 2-key report.
The battery health factor shall determine whether or not the printer can
operate and what is communicated to the user via the display.
Health has three states: Good, Replace and Poor.
If health = Good, then no action is taken. Normal printing operation is
permitted.
If Health = Replace, then a reminder message is displayed on the screen
for 10 seconds at power-up. Normal operation shall then commence
message.
“Please Replace Battery Pack”
The warning shall be accompanies by three beeps in rapid succession.
“Warning - Battery is Past its Useful Life”
The warning shall be accompanies by a series of three double beeps in
rapid succession.
If Health = Poor, then the following message is displayed on power-up for
30-Seconds. The message shall flash on and off and shall be accompanied
by beeping at the rate of once per second. After the 30-second interval, the
printer shall shut down.
“Please Replace Battery Before Proceeding – Shutting Down.”