Zebra RW 420 Installation And User Manual - page 16
UMAN-RW4PS-101 • EN-22
CAUTION: Do not attempt to replace this fuse with a higher amperage fuse.
Damage to the charger and/or the printer may result.
Securing the Power Cable
Secure the Input Power every 12 inches (30 cm) with adjustable
cable clamps or nylon wire wraps. Make sure that the cable rout-
ing does not interfere with other equipment or vehicle controls.
Ensure that the cable routing protects the cable from damage dur-
ing vehicle use.
Finish the Route Solutions Vehicle Cradle Installation
Route Solutions Vehicle Cradle Location
Locate the Route Solutions Vehicle Cradle in a location that al-
lows convenient access to the system. Follow these guidelines:
• Allow adequate clearance for the removal and replacement
of the RW 420 Print Station on the Route Solutions Vehicle
Cradle.
• Locate the Route Solutions Vehicle Cradle and the RW 420
Print Station in the vehicle so that it will avoid contact with
the operator in case of an accident.
• Make sure that cable routing does not invite damage to the
cable.
• Plug the power input cable into the mating plug on the
Route Solutions Vehicle Cradle. Use the cable retention
features on the bottom of the charger and holder module
to route the power input cable’s exit from the module.
• Secure the Route Solutions Vehicle Cradle, with #8 [4 mm]
hardware where indicated in Figure 2 at “A”. Insure that the
mounting hardware will not become loose due to vibration
by using locking hardware or prevailing torque fasteners.
• Follow the installation and safety guidelines included in the
Charger/Holder Installation manual.