Zebra RW 420 Installation And User Manual - page 15
UMAN-RW4PS-101 • EN-21
to the vehicle power source. The installer must find the nearest
practical connection point to the main battery’s voltage. It may be
possible to use internal wiring supplied in the vehicle, but only if
the wire gauge is equal to or greater than 18 AWG.
CAUTION: There must be a fuse between the vehicle’s power source and
the input power cable connection!
The capacity of the fuse between the vehicle’s power source
and the charger should not exceed 2.2A. Consult the vehicle
manufacturer or a dealer to determine the best power connection
location.
NOTE: Actual cable termination used must be compatible with the power
source. The following is only a guideline.
1. Cut the RED wire as near to the power source as practical.
2. Cut the BLACK wire to length to the nearest practical chas-
sis ground.
3. Strip 1/4” (6 mm) of insulation from the BLACK wire.
4. Securely crimp a 3/8” terminal ring onto the BLACK wire.
5. Strip 1/4” (6 mm) of insulation from the RED wire.
6. Securely crimp a 3/8” terminal ring onto the RED wire.
7. Ensure that cable terminals are well connected to the cable.
8. Connect black cable ground (-) terminal to vehicle ground
location.
9. Connect red cable power (+) terminal to vehicle power
source.
Cigarette Adapter Cable Installation (AK17463-007)
No input power cable preparation is necessary. Plug the ciga-
rette lighter adapter into the vehicle’s cigarette lighter power
socket. The appropriate fuse is integrated with the adapter. The
LED on the adapter will light, indicating that power is applied to
the charger. If the LED does not light, this may indicate that the
internal fuse in the adapter is blown. A 5 Ampere, 250 Volt, Type
312 fuse is integrated with the adapter.