Zebra RW 420 Installation And User Manual - page 18
UMAN-RW4RP-103 • EN-24
Installation with the Vehicle Cradle.
When not in use, the RW 420 Print Station should be installed
on its Route Solutions Vehicle Cradle. This will retain the Print
Station securely, and ensure that the batteries of the terminal and
Print Station are always at an optimum charge.
To install the Print Station on the Charger/Cradle:
• Align the two slots on the bottom edge of the Print Station
with the retaining pins on the storage and charge module.
• Rock the top edge of the Print Station towards the storage
and charge module until the locking latch on the module
engages securely with the Print Station.
To remove the RW 420 Print Station from the Charger/Cradle:
• Press the green Latch Release Button on the Charger/
Cradle module. (Refer to Figure 4)
• Rock the top edge of the Print Station away from the stor
-
age and charge module and lift the Print Station away from
the Charger/Cradle.
Use of the External Power Supply
The RW 420 Print Station may also be used with an optional ex-
ternal AC power source. (Refer to table on page. 7 for order part
numbers and descriptions.)
To use the Print Station with the external power supply:
• Plug the output cable of the power supply into the power jack.
The power jack is located under the protective flap in the lower
left corner of the Print Station when viewed from the front.
• Plug the Power Supply into a compatible AC power source.
Ensure you have the correct AC power cable for use in your
locality. The Power Supply will adjust to most AC voltages and
frequencies automatically.
Charger status Indicators
Whenever the Print Station is either charging in the Route solu-
tions Vehicle Cradle, or has been attached to power through the
external power supply, the battery icon on the LCD will cycle
through the charge level bar. It stops when the battery is fully
charged. The LED around the RW4-PS will illuminate when power
is applied to the RW4-PS
Terminal Battery Recharging
The yellow LED on the terminal indicates the status of the
terminal battery recharging. The LED will normally light when re-
charging is complete.