Zebra RW 420 Installation And User Manual - page 14
UMAN-RW4PS-101 • EN-20
voltage drops encountered across splices and other discontinui-
ties.
Installation General Guidelines
Follow the general guidelines below and other safety instruc-
tions closely when installing the Input Power cables.
CAUTION: Ensure that the input power cable you are using for this
installation is clearly labeled for use with the vehicle’s voltage.
NOTES: 1. It is the installer’s responsibility to insure correct wiring and
installation.
2. Zebra is not liable for damage to any equipment caused by improper
installation or wiring of the Route Solutions Vehicle Cradle, or damage
resulting from use of the wrong Route Solutions Vehicle Cradle for the
intended application.
3. Do not lengthen the input power cable. Extending the cable will affect
the systems’s reliability and radio frequency interference (RFI). Do not
attach any ground wires to the Route Solutions Vehicle Cradle housing.
4. Use care when attaching the converter’s power cable to the power
source. The red wire attaches to the positive (+) terminal and the black
wire to the negative (-) terminal. If wired backwards, the Route Solutions
Vehicle Cradle and/or the Print Station could be rendered inoperable and
will need to be sent to an authorized service provider for repair.
CAUTION: High voltages may be present. Always disconnect the vehicle’s
primary battery before installing any Print Station system component.
• Completely install the input power cable before connecting
the unit(s).
• Route the Input Power cable from the general area where
the unit(s) will be mounted.
• Use a snap-in bushing if the Input Power cable passes
through the vehicle’s fire wall or other sheet-metal barriers.
• Ensure that cable routing does not interfere with other
equipment or vehicle controls.
• Make sure that cable routing does not invite damage to the
cable.
• Secure the Input Power at least every 12 inches [30 cm]
throughout the cable run.
Input Power Cable Installation (AK17463-006)
CONNECTION TO POWER SOURCE WITH UN-TERMINATED
CABLE
You must cut the cable to length and strip the individual wire
ends of the cable. Finally, you must complete the connections