3Com 4007 Release Note - page 108
108
C
HAPTER
8: S
OFTWARE
I
NSTALLATION
Installing EMC Boot
Software
To upgrade a module’s EMC boot software to version 2.1, enter the
following commands and information:
When downloading this software to either a Master/Primary module or a
Slave/Secondary module, use this command:
CB9000> download module address> emc20100.bt Where is either 8.1 or 9.1 and is the IP address of the server where the software image resides. The system indicates that downloading software will cause the module to reset and asks if you want to continue. Enter y (yes). Installing EMC Operational Software To upgrade a module’s EMC operational software to version 3.0.0, enter the following commands and information: When downloading this software to either a Master/Primary module or a Slave/Secondary module, use this command: CB9000> download module address> emc30000.op Where is either 8.1 or 9.1 and is the IP address of the server where the software image resides. The system indicates that downloading software will cause the module to reset and asks if you want to continue. Enter y (yes).