3Com 4007 Release Note - page 93
SNMP Traps
93
Examples
Examples of setting the link state and topology change traps through the
EME console with accompanying displays of the trap outputs to the
console are shown here.
CB9000> set snmp trap filter link_state enable
Link state trap set to ENABLE.
CB9000>
Event Received: “SNMP Trap” Event generated:
2000-02-08T16:31:54 Entry: 00812 Slot: 09.02 Id: 00297
Severity: Inform Type: Trap Enterprise: CoreBuilder-9000 Trap
source slot: 03.01 Trap info: Link Down Octet string:
Corebuilder 9000-10 Port 100FX Layer 3 Switching Module,
manuf: 3Com, Fast-Ethernet Port 1
CB9000> set snmp trap filter link_state disable
Link state trap set to DISABLE.
(No subsequent generation of the link state traps occurs.)
CB9000> set snmp trap filter topology_change enable
Spanning tree topology change trap set to ENABLE.
Event Received: “SNMP Trap” Event generated:
2000-02-08T16:32:31 Entry: 00816 Slot: 09.02 Id: 00297
Severity: Inform Type: Trap Enterprise: dot1dBridge Trap
source slot: 03.01 Generic trap: 6 Specific trap: 2
CB9000> set snmp trap filter topology_change disable
Spanning tree topology change trap set to DISABLE.
(No subsequent generation of the topology change traps occurs.)
Only the topology change trap is filtered with this command. You will
continue to see any new root traps. A topology change trap has a specific
trap of two. A new root trap has a specific trap of one.