3Com 4007 Release Note - page 92
92
C
HAPTER
7: D
OCUMENTATION
C
HANGES
■
reset module all warm
— Use this command to reset all modules,
excluding the EME, without executing diagnostics.
SNMP Traps
There are two topics that deal with SNMP traps:
■
EME Command Changes in Release 3.0.5
■
Setting SNMP Trap Destinations
EME Command
Changes in
Release 3.0.5
This section reviews the EME interface command structure for SNMP
traps in software release 3.0.0, then shows the modifications that were
made in software release 3.0.5.
Old command structure in software release 3.0.0:
set
eme
trap_receive
disable/enable
set snmp
authentication_trap
disable/enable
show
snmp
authentication_trap extensions
set
trap_destination
New command structure in software release 3.0.5:
set
snmp
trap
destination
filter
authentication
disable/enable
link_state
disable/enable
topology_change disable/enable
receive
disable/enable
show snmp
extensions
trap
clear snmp
trap
The
show eme
display has been modified in this release. In version 3.0.0,
the
show eme
command displayed Trap Receive status (ENABLED or
DISABLED). In version 3.0.5, Trap Receive status is shown under the
show
snmp trap
command.