3Com 4007 Release Note - page 94
Other manuals for 4007:
Getting Started Manual, Important Notice, Command Reference Manual, Implementation Manual
Manual is about: 3Com 4007: Install Guide
of
128
94
C
HAPTER
7: D
OCUMENTATION
C
HANGES
Setting SNMP Trap
Destinations
The following EME command is not documented in Switch 4007
Implementation Guide:
■
set snmp trap destination
— Use this command to set a Simple
Network Management Protocol (SNMP) trap to a specific destination.
The correct syntax for this command is:
> set snmp trap destination
Where
is the community string of the selected trap where
you want to send the trap and
is the IP address of the trap
receiver.