3Com 4007 Release Note - page 25
Trap Filtering
25
The
set snmp trap
command enables you to configure trap
destinations, filters, and trap receive settings.
set snmp trap
destination
Set the trap destination. The system
prompts for an IP address.
filter
link_state
enable
disable
Enables or disables the generation of
link state traps.
topology_change
enable
disable
Enables or disables the generation of
topology change traps.
authentication
enable
disable
Enables or disables the generation of
authentication traps.
receive
enable
disable
As a trap receiver, the EME receives
traps from other SNMP devices,
including other CoreBuilder 9000
modules, that have the EME IP
address in their community table.
You can specify the network
management stations that receive
alerts from the EME. To do so, you
must create a new community table
entry for each network management
station.
Note that SNMP traps are
transmitted only through an in-band
IP routing interface.