3D Systems CubePro User Manual - page 23

19

3D Systems, Inc

.

19 .  Apply two thin layers of Cube Glue to the print pad . Select the 

checkmark

 to 

continue . 

NOTE: For more information, refer to the section titled “Applying 

Cube Glue .”

NOTE: Apply enough glue to cover a square area of 5”/15 cm in the 

center of the print pad .

NOTE: For best results, ensure the glue is dry prior to printing .

NOTE: Print jet 1 will begin to heat .

NOTE: The printer will begin printing the welcome message test 

print .

20 .  Select the 

checkmark

 to continue to go to the main menu .

NOTE: Please wait while the print jet cools .