3D Systems CubePro User Manual - page 64

60

3D Systems, Inc

.

5 .  Select the lower middle triangle .

6 .  Once the print jets have moved to the front center of the print pad, slide the 

paper between the print jets and the print pad . 

NOTE: If there is a slight resistance, proceed to step 8 .

7 .  If there is no resistance on the paper when sliding it between the print jets and 

the print pad, rotate the adjustment knob counter-clockwise (from the bottom) 

until there is a slight resistance .

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur .

NOTE: If the paper can not be inserted between the print jets and the 

print pad, turn the adjustment knob clockwise (from the bottom) until 

there is a slight resistance on the paper .

8 .  Select the upper left corner of the triangle .

9 .  Once the print jets have moved to the left rear of the print pad, slide the paper 

between the print jets and the print pad . 

NOTE: If there is a slight resistance, proceed to step 11 .

10 .  If there is no resistance on the paper when sliding it between the print jets and 

the print pad, rotate the adjustment knob counter-clockwise (from the bottom) 

until there is a slight resistance .

CAUTION: If the print pad is set too high, damage to the print pad or 

print jets may occur .

NOTE: If the paper can not be inserted between the print jets and 

the print pad, turn the adjustment knob clockwise (from the bottom) 

until there is a slight resistance on the paper .

11 .  Once completed, select the 

checkmark

 to exit the utility .