3D Systems CubePro User Manual - page 69

65

3D Systems, Inc

.

Incorrect Closed Z-Gap

If there is a gap (B) between the Closed Z-Gap bars and the baseline (A), 

turn all three print pad adjustment knobs counter-clockwise (left) 1-step and 

then print the file again to verify the lines touch. If the lines do not touch on 

the second print, adjust the knobs again 1-step and reprint the file. Continue 

to do this until the lines meet .

Correct Open Z-Gap

If there is a gap (B) between the Open Z-Gap bars (C) and the baseline (A) 

and there is no gap between the Closed Z-Gap bars and the baseline, the 

Z-Gap is correct .

Incorrect Open Z-Gap

If there is no gap (B) between the Open Z-Gap bars (C) and the baseline 

(A), turn all three (3) print pad adjustment knobs clockwise (right) 1-step 

and print the file again to verify that the lines do not touch. If they touch on 

the second print, adjust all three (3) print pad adjustment knobs clockwise 

(right) 1-step and reprint the file. Continue this procedure until there is a 

gap .

A

B

B

B

B

A

C

C

B

B

A