3D Systems CubePro User Manual - page 58

54

3D Systems, Inc

.

SETTING UP AN AD HOC NETWORK

An ad hoc network is a temporary yet direct connection between a computer or device and the printer . It does not connect through 

a router or base station and the data transfer rates are slower than the transfer rate of standard wireless networks . The computer or 

device you wish to connect ad hoc to the printer must have an ad hoc adapter installed . An ad hoc network is deleted when the user 

has disconnected from it or is out of range of other devices on the network unless it has been made a permanent network .

1 .  Select 

SETUP

 from the home screen .

2 .  Using either the left or right the navigation arrows, navigate to the 

Network

screen .

3 .  Select 

WIFI

 .

4 .  Select 

ADHOC

 from the Select WIFI Connection Type screen .

5 .  Select the 

ON/OFF

 bar to turn on the ad hoc network connection .