3D Systems CubePro User Manual - page 29

25

3D Systems, Inc

.

7

 PRINTING YOUR CREATION

There are many 3D creations available at www .cubify .com . In addition, you can create your own with the included Cubify Invent 

software. For more information about  converting a .stl file into a .cubepro file which the printer can use, refer to the section titled 

CubePro Software

 .

PRINTING PROCEDURE

The following steps illustrate how to print a creation .

1 .  After powering up your printer and turning on your display, press the 

touchscreen

 to begin .

2 .  Select 

PRINT

 .

NOTE: If the file is saved on a USB mass storage device, insert the 

device into the USB port on the printer . 

NOTE: You can also print directly from the CubePro software using a 

wireless connection .

3 .  Using the arrows, navigate to your file and select 

PRINT

 . 

NOTE: The file name will be displayed at the top.

NOTE: If the print file requires PLA material and ABS material is 

installed, the printer will prompt you to change the cartridge(s) . Select 

CHANGE CARTRIDGE

 and refer to the section titled 

Replacing A 

Material Cartridge

 .