3D Systems CubePro User Manual - page 24
20
3D Systems, Inc
.
MENU OVERVIEW
Touchscreen Display
After powering on the printer and turning on the touchscreen display, touch the
display to continue .
CAUTION: When using the touchscreen, use only light finger
pressure to make selections . Using anything sharp will damage the
touchscreen display and will void the manufacturer’s warranty.
Print / Setup
allows the user to print a creation stored either on a USB mass storage
device or from the CubePro software . You can invent your own creation by using
Cubify Invent software available at
www .cubify .com
.
SETUP
allows the user to configure the printer, connect to a wireless or ad hoc
network, install cartridges, or view the printer status .
Navigation
Navigation between screens is performed by pressing the right or left arrows .
Materials
CARTRIDGE STATUS
allows the user to view the type and color of the material that
is installed . It also displays the estimated amount of material left in the cartridge .
Selecting
CHANGE CARTRIDGE
allows the user to install cartridges in empty bays
or replace installed cartridges .
Print Plate Calibration
MOVE JETS
allows the user to manually move the print jets in the X and Y
directions .
LEVEL PLATE
is a utility that assists in leveling the print pad to the print jets .