3M LM1 User Manual - page 10
8
(English)
EN
PERFORMING TESTS ON TEST POINTS WITHIN SAMPLE PLANS
Performing an ATP Test on a Test Point within a Sample Plan
1. To start a new run, tap the Sample Plan, then tap
[New Test Run…].
• If a Sample Plan does not appear, tap scroll up
or scroll down
or swipe the list up or down to display
additional Sample Plans.
Or, if you are restarting a Sample Plan that you did not complete, tap the Sample Plan, then tap the starting date and
time you want to restart.
• If a starting date and time does not appear, tap scroll up
or scroll down
or swipe the list up or down.
• The List View appears, showing a list of the Test Points in the Sample Plan, and the number of Test Points in each
result category:
Total number of
Test Points
Number in
Pass
category
Number in
Caution
category
Number in
Fail
category
• To select a Test Type, tap
[Test types…] then tap the Test Type to be performed.
2. To select a Test Point to be tested, tap the Test Point.
• You can test the Test Points in sequence or in any order.
• If a Test Point does not appear, tap scroll up
or scroll down
or swipe the list up or down to display
additional Test Points.
• To display a different Test Point, tap Next Test Point Name or Previous Test Point until the Test Point you want
appears.
• To display a picture and a description of the test point, tap information
next to the Test Point name. Tap Back
to return to the previous screen.
3. Follow the Instructions for Use for the 3M Clean-Trace Tests. Collect a sample, activate the test and shake it for at least
5 seconds.
a. Open the 3M Clean-Trace Luminometer by pressing the rocker cap. Then insert the activated test into the chamber.
Keep the 3M Clean-Trace Luminometer upright whenever a test is in the chamber to ensure accurate results and
avoid spillage of reagents, which could damage the sensitive components of the instrument.
b. Tap
[Start]
to begin measuring. A progress bar
appears and moves from left to right.
c. The test result appears and is stored in the memory so it can be synchronized with the 3M Clean-Trace Hygiene
Management Software. The result is also interpreted using your established pass/fail limits and is displayed on the
screen as
PASS
,
CAUTION , or FAIL .
d. To remove the 3M Clean-Trace Test from the 3M Clean-Trace Luminometer, press the rocker cap, grasp the top of
the test and pull upwards. Follow the instructions for disposal in the 3M Clean-Trace Test Instructions for Use.
4. To test another Test Point, tap Next Test Point or Previous Test Point until the Test Point you want appears.
• Or, to do a retest, tap
[Retest]
then tap
[Start]
.
• Or, to display the list of Test Points, tap
[List View]
.
Performing a Retest on an ATP Test Point with a Caution or a Fail Test Status before Moving to a Different Test Point
1. Before moving to a different Test Point, follow the Instructions for Use for the 3M Clean-Trace Test to collect a sample,
activate the test, and shake it for at least 5 seconds.
2. Open the 3M Clean-Trace Luminometer by pressing the rocker cap. Then insert the activated test into the chamber.
Keep the 3M Clean-Trace Luminometer upright whenever a test is in the chamber, to ensure accurate results and avoid
spillage of reagents, which could damage the sensitive components of the instrument.
3. Tap
[Retest]
then tap
[Start]
to begin measuring. A progress bar
appears and moves from left to right.
4. The test result appears and is stored in the memory so it can be synchronized with the 3M Clean-Trace Hygiene
Management Software. The result is also interpreted using your established pass/fail limits and is displayed on the
screen as
PASS
,
CAUTION or FAIL .