3M LM1 User Manual - page 11
9
(English)
EN
5. To remove the test from the 3M Clean-Trace Luminometer, press the rocker cap, grasp the top of the test and pull
upwards. Follow the instructions for disposal in the 3M Clean-Trace Test Instructions for Use.
Performing a Retest on an ATP Test Point with a Caution or a Fail Test Status after Moving to a Different Test Point
To select the Test Point you want to retest while in the same Sample Plan, tap Next or Previous .
• Or, to use a different Sample Plan, tap Home
, then tap the Sample Plan, then tap the date and time of the run.
• Or, tap Scroll down
or Scroll up
then tap the Test Point you want to retest.
1. Follow the Instructions for Use for the 3M Clean-Trace Test to collect a sample, activate the test and shake it for at least
5 seconds.
2. Open the 3M Clean-Trace Luminometer by pressing the rocker cap. Then insert the activated test into the chamber.
Keep the 3M Clean-Trace Luminometer upright whenever a test is in the chamber, to ensure accurate results and avoid
spillage of reagents, which could damage the sensitive components of the instrument.
3. Tap
[Retest]
then tap
[Start]
to begin measuring. A progress bar
appears and moves from left to right.
4. The test result appears on the screen and is stored in the memory so it can be synchronized with the 3M Clean-Trace
Hygiene Management Software. The result is also interpreted using your established pass/fail limits and is displayed on
the screen as
PASS
,
CAUTION or FAIL .
5. To remove the test from the 3M Clean-Trace Luminometer, press the rocker cap, grasp the top of the test and pull
upwards. Follow the instructions for disposal in the 3M Clean-Trace Test Instructions for Use.
Performing a Visual Inspection Test on a Test Point within a Sample Plan
1. To start a new run, tap the Sample Plan, then tap
[New Test Run…].
• If a Sample Plan does not appear, tap scroll up
or scroll down
or swipe the list up or down to display
additional Sample Plans.
Or, if you are restarting a Sample Plan that you did not complete, tap the Sample Plan, then tap the starting date and
time you want to restart.
• If a Sample Plan does not appear, tap scroll up
or scroll down
or swipe the list up or down to display
additional Sample Plans.
• The List View appears, showing a list of the Test Points in the Sample Plan, and the number of Test Points in each
result category:
Total number of
Test Points
Number in
Pass
category
Number in
Caution
category
Number in
Fail
category
• To select a Test Type, tap
[Test types…] then tap the Test Type to be performed.
2. To select a Test Point to be tested, tap the Test Point.
• If a Test Point includes an ATP test and a Visual Inspection test, the Visual Inspection test appears immediately after
the ATP test.
• You can test the Test Points in sequence or in any order.
• If a Test Point does not appear, tap scroll up
or scroll down
or swipe the list up or down to display
additional Test Points.
• To display a different Test Point, tap Next Test Point Name or Previous Test Point until the Test Point you
want appears.
• To display a picture and a description of the test point, tap information
next to the Test Point name. Tap
[Back]
to return to the previous screen.
• Tap
[Pass] for a Pass result or tap [Fail] for a Fail result.
• If you selected Pass, the Pass display
appears. If you entered Fail, the Fail display appears.
• To redo a test, tap
[Retest]
then tap
[Start]
.