4RF Aprisa SR+ User Manual - page 213
Maintenance | 211
Aprisa SR User Manual
Single Radio Software Upgrade
The software upgrade procedure is different for an Aprisa SR Protected Station (see ‘Protected Station
Software Upgrade’ on page 32).
Note: If a radio has been configured for a Protection Type of ‘Redundant’ (see ‘Protected Station:
Terminal > Operating Mode’ on page 169), and that radio is no longer part of a Protected Station, the
Protection Type must be changed to ‘None’ before the radio software upgrade can be achieved.
File Transfer Method
This process allows customers to upgrade a single Aprisa SR radio.
The Software Pack is loaded into the radio with the file transfer process (see ‘Software > File Transfer’ on
page 146) and activated (see ‘Software > Manager’ on page 149).
Upgrade Process
The Aprisa SR upgrade operation is indicated by a flashing orange AUX LED.
To upgrade the Aprisa SR radio software:
1. Unzip the software release files in to the root directory of a USB flash drive.
2. Check that the SuperVisor USB Boot Upgrade setting is set to ‘Disabled’ (see ‘Software > Setup’ on
page 145).
3. Insert the USB flash drive into the Host Port
.
4. Using File Transfer, load the software pack into the radio (see ‘Software > File Transfer’ on page 146).
5. Activate the software on the radio (see ‘Software > Manager’ on page 149).