4RF Aprisa SR+ User Manual - page 81
Managing the Radio | 79
Aprisa SR User Manual
RF NETWORK DETAILS
Network ID (FAN)
This parameter sets the network ID of this base station node and its remote / repeater stations in the FAN.
The entry is four hexadecimal chars (not case sensitive). The default setting is CAFE.
Network Radius
This parameter sets the maximum number of hops in this network e.g. if the Network Radius is set to 2, a
message from that node will only pass 2 hops before it is blocked. The default setting is 1.
All stations in the FAN should be set to the same value.
Network Repeaters Proximity
This parameter is set in base stations and repeater stations to indicate the proximity of repeaters in the
FAN. It has no affect if the Network Radius is set to 1.
The default setting is Separated Coverage.
Option
Function
No Repeater
No repeater in the FAN.
Single Repeater Only
Only one repeater in the FAN.
Overlapping Coverage
Multiple one hop repeaters where the remote station can see more
than one repeater.
Separated Coverage
Multiple one hop repeaters where the remote station can only see
one repeater. This option provides better network performance
than the Overlapping Coverage option.
Inband Management
This parameter sets the Inband Management option.
If the Inband Management option is enabled, SuperVisor operating on a base station can also manage all
the remote / repeater stations in the FAN.
Inband Management Timeout (sec)
This parameter sets the Inband Management timeout period. This determines the time the base station
waits for a response from a Remote or repeater station before aborting the Inband Management request.
The default setting is 10 seconds.