Bakers & Chefs 9905TB Assembly & Operating Instructions - Assembly Instructions
Assembly Instructions
COOKING COMPONENT INSTALLATION
Place Steel Flame Tamers on the lower ledge of
Grill Bowl. See ILL. 10.
Place Cast Iron Cooking Grids on the ledge of
Grill Bowl above Flame Tamers.
1.
2.
WARNING :
Now your gas grill is ready to use. Before
first use and at the beginning of each
barbecue season and whenever LP gas
cylinder is changed.
1.
2.
3.
Please read safety, lighting and operating
instructions carefully.
Check gas valve orifices, venturi tubes and
burner ports for any obstructions.
Perform gas leak check (see page 2).
IMPORTANT:
The Grill is not designed for use with
lava rock or briquettes and the use of such items will
void the warranty.
CONNECTING TO GAS SOURCE
1. Insert the Tank-Holding Strap through the two (2)
slots on Side Panel. See ILL. 11. Hang filled
gas tank on the Tank Hook attached to the Grill
Bowl. The ring foot of the gas tank will rest on
the Tank Holder. Fasten the gas tank using the
Tank-Holding Strap. Make sure tank valve is in
its full off position (Turn clockwise to stop).
Check tank valve features to ensure it has proper
external mating threads. (Type 1 connection per
10-94 AGA Requirement)
Make sure all burner valves are in their off position.
Inspect valve connection ports and regulator as-
sembly. Look for any damage or debris. Remove
any debris. Inspect hose for damage. Never
attempt to use damaged or plugged equipment.
See your local LP gas dealer for repair.
When connecting regulator assembly to the tank
valve, hand tighten nut clockwise to a positive stop.
Do Not use a wrench to tighten. Use of a wrench
may damage quick coupling nut and result in a
hazardous condition.
Open tank valve fully (counter-clockwise). Use a
soapy water solution to check all connections for
leaks before attempting to light grill. If a leak is
found, turn tank valve off and do not use grill until
repairs can be made by a local LP gas dealer.
2.
4.
3.
5.
6.
CAUTION:
When the appliance is not in use, the
gas must be turned off at the supply cylinder.
To disconnect LP gas cylinder:
a) Turn the burner valve off.
b) Turn the tank valve off fully.( Turn clockwise to stop.)
c) Detach the regulator assembly from tank valve by
turning the quick coupling nut counter-clockwise.
PAGE 11
These holes are for rotisserie mounting bracket use.
ILL. 10
CAST IRON
COOKING GRID
STEEL FLAME
TAMER
ILL. 11
REGULATOR
COUPLING NUT
TANK-HOLDING
STRAP
TANK HOOK
TANK HOLDER
SIDE PANEL