Bakers & Chefs 9905TB Assembly & Operating Instructions - page 12
Become familiar with safety guidelines at front of
manual. DO NOT SMOKE WHILE LIGHTING GRILL
OR CHECKING GAS SUPPLY CONNECTIONS!
Check to see that cylinder is filled.
Check that end of each burner tube is properly located
over each valve orifice.
Make sure all gas connections are securely tightened.
TEST FOR LEAKS WITH A SOAP SOLUTION,
NEVER WITH A FLAME.
(Gas Leak Check
instructions are on page 1).
Always open lid before lighting.
Set control knobs to "OFF" and open the gas supply
cylinder valve.
Igni
te onl
y the burners you i
ntend to use, usi
ng the
sam e
m ethod
for
each:
Adj
ust
control
knob(s)
to
desi
red
tem perature.
Lighting & Operating Instructions
LIGHTING PROCEDURES
1.
2.
3.
4.
5.
6.
7.
Turn off gas at source, turn control knob to "OFF", and
wait five minutes before trying again.
Check gas supply/connections.
Repeat lighting procedure and , if grill still fails to
operate properly, TURN "OFF" GAS AT SOURCE,
TURN CONTROL KNOBS TO " OFF", wait for grill to
cool and check the following:
1.
Misalignment of burner tube(s) over orifice(s).
CORRECTION: Reposition burner tube to properly
seat over orifice.
Obstruction in gas line
CORRECTION: Remove fuel line from grill. DO NOT
SMOKE! Open gas supply for one second to blow any
obstruction from fuel line. Close off gas supply at
source and reconnect fuel line to grill.
Plugged orifice
CORRECTION: Remove cooking grids and flame
tamers. Remove burners from bottom of grill bowl by
pulling cotter pin from beneath burner "foot" using a
screwdriver or needlenose pliers. Carefully lift each
burner up and away from gas valve orifice. Unscrew the
orifice from each gas valve and gently clear any
obstruction with a fine wire. Re-install each orifice, re-
install burners over orifices and seat each burner "foot"
into mounting bracket at bottom of grill bowl. Replace
cotter pins and cooking components.
If an obstruction is suspected in gas valve(s) or gas
valve bracket, please contact your local LP gas service
person for assistance.
Misalignment of ignitor on burner
CORRECTION: Check for proper position of electrode
tip. The tip of the electrode should be pointing toward
the tip of the collector box. The gap between the spark
electrode and the tip of the gas collector box should
be 3/16". Adjust if necessary. With gas supply closed
and all control knobs set to "OFF" check each positive
ignitor individually for presence of spark at electrode.
In turn, push each control knob in fully and rotate about
1/4 turn to the left (counter-clockwise) until a click is
heard; the trigger hitting the strike block should pro-
duce a blue spark at the electrode tip. Return control
knob to "OFF" before checking next ignitor.
If re-ignition is necessary while the gas grill is still hot, you
must wait for a minimum of five minutes before commenc-
ing to re-ignite (this allows accumulated gas fumes to
clear).
If all checks/corrections have been made and gas grill still
fails to operate properly, contact the Grand Hall Service
Center, or your local LP gas service person.
FLASH BACK:
Should fire occur in and around the burner tubes, imme-
diately turn off gas at its source and turn the control
knob(s) to "OFF". Wait until the grill has cooled, then clean
the burner tubes and burner ports as described on page
4.
a.
b.
c.
d.
8.
Open lid.
Push Control knob in and HOLD it down while you
turn knob left about 1/2". This allows gas to collect.
After holding for 2 seconds, turn knob leftward to the
ignition point (see lightning bolt). You may need to
re-click ignitor 3 or 4 times to light.
If burner does not light, turn gas off and wait 5
minutes before retrial. If unsuccessful after retrial,
wait a few minutes and light by match.
a.
b.
c.
d.
NOTE: As long as one ignitor is in working order, other
burners can be ignited from operating burner, in succes-
sion. If, for some reason, all ignitors fail to produce a spark
at the electrode tip, grill can be lit with a paper book match.
NOTE: To light gas grill with a match, follow steps 1 to 6 above.
Then, insert lit paper book match with lighting stick through
the lighting hole on right side of grill bowl. Press in right
control knob and rotate left to "HI" setting to release gas.
Burner should light immediately. If more burners are
needed, press in and rotate next control knob to light burners
in succession. Turn off burners not needed, and adjust to
desired cooking temperature. See Page 14, ILL. 12.
CAUTION: Do not move trolley while grill is in operation.
If the grill fails to operate properly:
2.
3.
PAGE 12