Bakers & Chefs 9905TB Assembly & Operating Instructions - Assembly Instructions
Assembly Instructions
1. Before installing the bottom shelf brackets, make
sure:
A)
the ledges of both bottom shelf brackets
face each other
B)
the bottom shelf bracket equipped
with door stop must be located in the front
C)
the
side of Cart Legs having a threaded hole for Door
Bracket must face inwards. Refer to ILL. 1.
Install the bottom shelf brackets between cart legs.
Align the threaded holes on the ends of bottom shelf
bracket with the holes on cart legs. Screw loosely
using 8 of the "B" 1/4" x 2-1/2" phillips head screws.
Insert the screw through the Cart Leg, then
match the screw end with the threaded hole on
the Bottom Shelf Bracket.
Attach the Tank Holder to the cross brace between
both Wheel-side Cart Legs as shown in ILL. 1. Align
the holes on Tank Holder with holes on the cross brace.
Fix firmly by using 2 of the "B" 1/4" x 2-1/2" phillips
head screws and 2 of the "L" lock nuts.
Install the Wheel to a Wheel-side Cart Leg by inserting
one "A" wheel bolt through the Wheel and Cart Leg
as shown in ILL. 2. Then tighten securely using one
"J" spring washer and one "M" 5/16" nut provided.
Snap Wheel Hub in place and repeat steps for second
wheel.
Secure the Caster to the bottom of the Castor-side
Cart Leg by turning the threaded caster stem
clockwise until full stop. Fasten firmly using a
wrench.
Attach the rear panel to the cart legs as shown in
ILL. 3. Align the holes on panel with the holes on
cart legs. Fix firmly by using 4 of the "G" 3/16"
x 3/4" phillips head screws provided.
Tighten the loosely attached screws in step 2 for
fastening both Cart Legs and Bottom shelf brackets
together.
Secure the Lighting Stick to the top of the right side
panel. The tapping screw is already attached to the
lighting stick.
Place the bottom shelf over the ledges of both bottom
shelf brackets.
Before attempting to assemble your gas grill, check that
all the necessary parts have been included using the
parts lists on page 5, 6 and 7. Inspect grill and trolley
parts for damage as you proceed. Contact our service
center regarding replacement of any damaged parts. Do
not assemble or operate a barbecue grill that appears
damaged.
While it is possible for an individual to assemble this
gas grill, we recommend asking for the assistance of
another person when maneuvering some of the larger
or heavier pieces. You may need both
Adjustable
Wrench
and
Phillips Screw Driver
(not provided) for
securing the nuts and screws.
HINT:
2.
3.
4.
6.
5.
7.
8.
PAGE 8
TANK
HOLDER
ILL. 1
DOOR
STOP
WHEEL-SIDE
CART LEG
CASTOR-SIDE
CART LEG
BOTTOM SHELF
BRACKET
THREADED HOLE FOR
DOOR BRACKET
ILL. 3
BOTTOM
SHELF
SIDE
PANEL
REAR
PANEL
LIGHTING
STICK
ILL. 2
WHEEL HUB
CASTER