Bakers & Chefs 9905TB Assembly & Operating Instructions - Safety Instructions
Safety Instructions
BURNER TUBE CLEANING
For cleaning the burner tubes. Follow the procedure
that is most convenient for you.
Remove burner assembly from the grill bowl.
Bend a stiff wire, (a light weight coat hanger works
well) into a small hook as shown below,
Run the hook up through each venturi tube and
into the burner several times.
1.
Run the brush up through each venturi tube and
into the burner several times.
SAFETY !
Use a bottle brush with a flexible handle.
2.
VERY IMPORTANT:
The location of burner with respect to orifice is vital for safe operation. Check to assure the valve
orifices are inside of the burner tubes before using your gas grill. See drawing below.
If the burner tubes (venturi) do not fit over the valve orifices, lighting the burners may cause explosion
and/or fire.
CARE AND MAINTENANCE
As with all appliances, proper care and maintenance
will keep them in top operating condition and prolong
their life. Your new gas grill is no exception. By
following these cleaning procedures on a timely basis,
your grill will be kept clean and working properly with
minimum effort.
FOLLOW THE BURNER AND BURNER TUBE
CLEANING PROCEDURE BEFORE ASSEMBLY OF
YOUR GRILL.
To reduce the chance of "Flash-back", the procedure
below should be followed at least once a month in
late summer or early fall when spiders are most active,
or when your grill has not been used for an extended
period of time.
Wire brush entire outer surface of burner to
remove loose corrosion.
Clean any clogged holes with a stiff wire (for
example: an open paper clip).
Inspect the burner assembly for any opening
caused by corrosion.
If openings due to corrosion are found, order a
new burner.
Replace the burner and cotter pin as described
in the assembly instructions.
Check the burner for proper location after replac-
ing.
Check to assure the valve orifices are inside of
the burner tubes.
Should "Flash-back" occur, immediately turn the con-
trol knobs to "OFF" and carefully turn the gas supply
off at the gas source.
1.
2.
3.
4.
5.
6.
7.
BURNER CLEANING
Regardless of which venturi cleaning procedure you
used, we recommend that you complete the following
steps to help prolong burner life.
Control Knob
Ignitor
Gas Valve
Orifice
Spark Electrode
Gas Collector Box
Burner
Burner Port
Burner Tube
section of Manifold
PAGE 4