Barbecook Quisson 4000 User Manual - page 12
12
www.barbecook.com
9.4.1 U
SING THE IGNITER
1
Open the lid and set the control knob of the spit burner to
OFF.
2
Remove the grills and warming rack from the appliance and
put them aside.
3
If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4
Push in the control knob of the spit burner, set it to HIGH
and hold it for a moment. The build-in igniter will cause
sparks, which will light the spit burner.
5
If the burner does not light after three attempts, set its
control knob to OFF, close the gas supply and wait 5
minutes. This allows any accumulated gas to escape.
6
Retry lighting the spit burner. If it still does not light, try
lighting it with a match or refer to “15 Troubleshooting” to
determine the cause of the problem.
9.4.2 U
SING A MATCH
1
Place a match in the match holder.
2
Open the lid and set the control knob of the spit burner to
OFF.
3
If no other burner is lit yet, open the gas supply and wait ten
seconds. This allows the gas to stabilize.
4
Light the match and hold it to the left of the spit burner.
5
Set the control knob of the spit burner to HIGH.
6
If the burner does not light within 5 seconds, set its control
knob to OFF, close the gas supply and wait 5 minutes. This
allows any accumulated gas to escape.
7
Retry lighting the spit burner. If it still does not light, refer to
“15 Troubleshooting” to determine the cause of the problem.
9.5 Switching the burners off
If you no longer use the burners, you have to switch them off.
Proceed as follows:
1
Close the gas supply.
2
Set the control knobs of the burners to OFF.
2
By closing the gas supply first, you make sure there is no
gas left in the appliance.
9.6 Relighting the burners
If a burner goes out while in use, proceed as follows:
1
Open the lid and close the gas supply.
2
Set all control knobs to OFF and wait 5 minutes. This allows
any accumulated gas to escape.
3
Relight the burner(s).
9.7 Checking the flames
Each time you light a burner, you have to check its flames. A
perfect flame is almost completely blue, with some yellow at the
top. Sporadic yellow flames are normal and not harmful.
If there is something wrong with the flames, do one of the
following to solve the problem:
10
USING THE TIMER AND
THERMOMETER
The appliance is equipped with a timer and thermometer. You
can use them to set an alarm, which can either go off after a
certain amount of time or when the food reached a certain
temperature. You can also use the thermometer to check and
follow up the temperature of your food.
2
If you do not use the thermometer, we recommend
storing the thermometer probe and cable indoors.
If the flames are...
Do the following...
Low and entirely yellow
1
Immediately close the gas supply and
set all control knobs to OFF.
2
Refer to “15 Troubleshooting” to
determine the cause of the problem.
Most likely, the venturis are blocked.
Higher than the bowl
1
Immediately close the gas supply and
set all control knobs to OFF.
2
Wait 5 minutes to allow any
accumulated gas to escape.
3
Relight the burner(s).
4
If the problem persists, refer to
“15 Troubleshooting” to determine
the cause of the problem.
LOW
HIGH
!gas_quisson_standard.book Page 12 Tuesday, September 2, 2014 2:13 PM