Bircher Reglomat PrimeTec User manual - page 2
Mounting the Sensor
3
Ensure door header cover-
plate is always in place and
held tightly by screws.
Mount the PrimeTec rain
cover, (PTCR) if sensor is
exposed to rain.
Obstruction can affect
performace. Ensure safety
& motion sensors have
unobstructed views.
Mount sensor away from
fluorescent or HID light
sources.
To remove cover once the sensor is
mounted on the door frame, grasp the
cover firmly on either side and pull to-
ward you.
Removing the Cover
3.2
Page 2
Warning: failure to follow these safety precautions may cause damage to sensor or objects, serious personal injury, or death.
-This product is designed to be mounted on the header of an automatic sliding or telescopic door.
-Do not use this product other than for its specified application.
-Observe all local, national, and international door safety standards, codes, and laws.
-Only trained and qualified personnel may install and initialize the sensor.
-Only authorized Bircher Reglomat personnel may perform hardware/software changes or repairs to the product.
-The unit should only be operated from a safety extra low voltage (SELV) system with safe electrical separation.
-Always consider the safety functions of your applications as a whole, never just in relation to one individual section of the system.
-The installer is responsible for testing the system to ensure it meets all applicable safety standards (e.g. ANSI 156.10).
-Never touch any electronic components or lenses.
Safety Precautions
2
General Safety
2.1
-Follow all steps outlined in this manual in order for proper installation of the product.
-Stop all pedestrian traffic through the door before installing sensor.
-Ensure there is no pedestrian traffic through the door until sensor is installed and tested for compliance with all applicable safety standards
(e.g. ANSI 156.10).
-Verify proper installation of door equipment before installing sensor.
-Shut off all power before attempting any wiring procedures.
-Always use wire terminals to terminate stranded wire ends.
-Check placement of wiring to ensure moving parts are not impeded by wires.
-Make sure wiring is correct before applying power to the sensor to avoid damage to equipment.
-Ensure door & header coverplate are properly grounded to protective earth (PE).
-Ensure (e.g. by walk testing) that installation is in compliance with all applicable standards (e.g. ANSI 156.10) after completion of installation.
-If the sensor sustains damages (e.g falls), replace it with a new unit.
-If a satisfactory solution cannot be achieved after troubleshooting a problem, please call Bircher Reglomat at 800-252-1272 or
visit our website at www.bircherreglomat.com.
DO NOT LEAVE ANY PROBLEMS UNRESOLVED! DO NOT SACRIFICE SAFETY FOR ANY REASON!
Installation Safety
2.2
Grasp cover firmly and insert one finger
beneath the mounting screw holes on the
sensor baseplate. Pull the sensor toward
you to remove the cover.
Special Considerations
3.1