Bircher Reglomat PrimeTec User manual - page 6
Standard Field
6.2
Adjusting the Safety Curtain Distance from the Door
––
++
0°
7°
-5°
7.1
Changing the Motion Field Pattern
Page 6
1/8 turn
≈ 1° ≈ 1”
Please refer to current published
ANSI standard for exact measure-
ments.
The built-in self-monitoring could
malfunction or indicate an error if
the safety curtain is angled too far
away from the door panel.
For troubleshooting, please see
section 9.
1
Rotate
Narrow Field
2
3
7
Motion Sensor Adjustment
The motion field pattern can be changed by rotating the microwave module.
1° of adjustment (1/8 or 45° turn with a
screwdriver), is approximately equal to 1”
of curtain movement on the floor.
Factory setting = 2°
2° (factory setting)
For assistance, use the measu-
ring guide on the front of the
manual to determine this
distance.
Hold the guide no more than
10” (25 cm) off the ground and
move it from the door opening
into the safety field until the
red LED illuminates.
Release the side clip
by hand or with a
screwdriver
Push module into place
until it clicks
Standard field microwave
module position
Narrow field microwave
module position